The installation instructions below should be followed when the SCRT is to be pole mounted and connect to an independently mounted antenna.
Place the SCRT on a flat surface with the RF connector facing up
Fix the sun shield (front) to the SCRT using the four M3 screws provided
Turn over and fix sun shield (rear) to the SCRT using the four M6 screws provided
Using the screws provided secure the brackets to the SCRT using a Pozi-drive screwdriver.
Fix the other half of the pole mount bracket to the pole as shown below using the two U bolts, nuts washers and spring washers provided.
Join together the two halves of the bracket and clamp with the Nut, Bolt, and Locking washers provided. The part of the bracket connected to the SCRT is designed to locate in the head of the bolt and stop it rotating. This allows the SCRT to be Vertically aligned.
Horizontal alignment is achieved by loosening the U-Bolts slightly and rotating around the pole.
Attach the Antenna feeder cable to the RF connector. Take a piece of self amalgamating tape about 5" long and weather seal the connector and cable. Stretch the tape when applying to obtain the best seal. Ensure the cable and connector are sealed
Attach the fibre and DC cables to the connectors at the base of the unit.
The picture below shows a completed installation.
