Airspan recommends that cables should be secured with Milli-Tie cables as these are designed to prevent over-tightening of cable ties. Over-tightening of cable ties may causes damage and degrade system performance.
The Milli-Tie can be used to secure cables in the same manner as normally used for nylon straps. The steps below show the basic use of the product.
Place the Mille-Tie around the target, and thread the tongue through the last LARGE aperture in the rearmost cell.
Pull or slide the Mille-Tie onto the target. Note that the Mille-Tie stretches to cushion the installation.
Release the tension when snug, then cut and remove any excess strip. Always cut through the square sections, not the wider cells.
Mille-Tie is very efficient, and simply gets a little shorter after each use. The remaining strip can be kept and used again and again.
Just keep repeating the same basic fitting procedure until the whole Mille-Tie is used up.
