SDR-micro Installation

 

Installing the SDR-micro Enclosure
SDR-micro Mounting Plate

The SDR-micro enclosure is fitted on to a mounting plate (Not provided by Airspan). The mounting should be drilled as shown below.

Fix

 

Mounting the SDR-micro

  1. Screw the four standoff fittings into the 8mm mounting holes on the heat sink of the SDR-micro enclosure.

  2. Loosely place two of the M8 screws and washers into the two standoff fittings at the top of the SDR-micro enclosure.

  3. Lift the enclosure and place the screws through the head clearance holes and lower the unit so that the top mounting holes retain the unit. Note: This unit weighs 25kg take care when lifting.

  4. Screw the bottom two the M8 screws and washers into the two standoff fittings at the bottom of the SDR-micro enclosure.

  5. Tighten all fixing screws.

 

  1. Attach the sun shield using the 4 screws and washers provided.