Testing Connect Plus Radios Radios require individual configuration to map the Groups created using Connect Plus with the radio’s Channel dial. Programming Connect Plus radios falls outside the scope of this document. In general, you require the PC client used to program the radio, and the programming connection cable for the radio. Configuration Requirements Connect Plus requires radio software version R01.04 and R01.05. A Motorola Option Board must be installed in the SU. Prior to the installation of MOTOTRBO™ Connect Plus Option Board firmware, the radio’s Option Board is referred to as a Generic Option Board (GOB). Following installation of Connect Plus software, the Option Board is referred to as Connect Plus Option Board. In order for the Connect Plus Option Board to enable its OTA interface and “talk” to the XRC 9000 controller, it must first verify that the Connect Plus feature has been enabled in the MOTOTRBO subscriber unit. Once you have successfully programmed the radios, ensure they can communicate before proceeding with WAVE 3000 Server configuration. Private Calls should be possible between individual radios, and channel communication should be possible over all groups programmed for the radios. To continue setup, follow the instructions in Accessing the WAVE 3000 Server.
